Internal brake resistance too low. Check cable particularly critical in the cable trailing device. Intervals are too short. No reference point set when a motion task is started. Tables of motion tasks with a time base which is too low. DC bus link breakdown. Position setting for software limit switch 2 SWE2 has been exceeded.
| Uploader: | Fautilar |
| Date Added: | 12 November 2010 |
| File Size: | 13.25 Mb |
| Operating Systems: | Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X |
| Downloads: | 74060 |
| Price: | Free* [*Free Regsitration Required] |
Feedback set up incorrectly. Power consumption of the plug-in card is too high. Check the motor temperature.
Monitor in the slave responds too soon after a restart. Servo amplifier not enabled.
Set the details for the internal or external braking resistor correctly on the Basic Setup screen page. Hardware error and the expansion driivegui. STO-Enable input is 0V with disabled drive only. Braking ramps too short. Status message, no error, programming mode. Extend the braking ramps on the Velocity Loop screen page.
DriveGUI Download -
For testing reasons only. Adapt parameters or hardware. Velocity Loop and possibly Position Loop screen pages. Motor does not rotate. Following error set too low. Re-enter parameters and save them.
DriveGUI Online Hilfe
Mains contactor not connected. Installed motor contactor has burnt contacts. No reference point set when a motion task is started. Check and switch on power supply. Undo the last configuration change.
Bridge must be removed from the connector! Speed in excess of permissible limit.
Cutoff threshold for the temperature sensor is set too low. Software enable not set. Amplifications set too low.
Limit switch Homing error. Break in setpoint cable.
Knowledge Base
Drive is mechanically blocked. Axis is too undynamic. Measure the sensor resistance.
Mount devices which generate electrical fields further away from the amplifier. Reduce EMC interference; check shielding and earthing. Motor default values loaded. Commenced motion task does not exist checksum is defective.
No comments:
Post a Comment